Brady X-Plus II User Manual
Page 152
Troubleshooting
LCD Error Messages
142
14068L-001 Rev. A
X-Plus II User Guide
1/11/07
The printer stops; the
ERROR light flashes.
Caution • The cutter blade is sharp. Do not touch or rub the blade
with your fingers.
Cutter blade is in the media path.
Turn off the print engine power and
unplug the printer. Inspect the cutter
module for debris and clean as needed
following the cleaning instructions in
There is not enough memory to
perform the function specified on
the second line of the error
message.
Free up some of the printer’s memory
by adjusting the label format or printer
parameters. One way to free up
memory is to adjust the print width to
the actual width of the label instead of
leaving the print width set to the
default. See
.
Ensure that the device, such as FLASH
memory or PCMCIA card, is installed
and not write protected or full.
Ensure that the data is not directed to a
device that is not installed or is
unavailable.
Call a service technician.
Table 11 • LCD Error Messages (Continued)
LCD Display/
Printer Condition
Possible Cause
Recommended Solution
ERROR CONDITION
CUTTER JAM
OUT OF MEMORY
(function)