Brady X-Plus II - Manual (Page 201)

191 Index
1/11/07 X-Plus II User Guide 14068L-001 Rev. A
F
factory defaults
reload parameters, 59
restore network settings, 59
fanfold media, 27
FCC compliance, iv
features, 176
FEED button
FEED and PAUSE self test, 158
FEED self test, 154
function, 11
Flash memory, 75
font list, 72
format convert setting, 88
format list, 73
format memory card, 74
format prefix setting, 80
fuse replacement, 134
H
hardware control signal descriptions, 164
HEAD COLD message, 141
head test setting, 84
HEAD TOO HOT message, 140
host handshake setting, 79
humidity requirements, 18
I
idle display setting, 88
images list, 73
initialize Flash memory, 75
initialize memory card, 74
inspect for shipping damage, 17
interfaces
IEEE 1284 bidirectional parallel, 21
print servers, 22
RS-232 serial, 20
USB, 22
international safety organization marks, 25
isolated mode for applicator control signals
+24-28V operation, 174
+5V operation, 173
J
jumper configurations for +24-28V operation, 174
jumper configurations for +5V operation, 173
L
label backing removal, 120
label length maximum setting, 68
label specifications, 182
label top
printer cannot detect, 150
setting, 82
label-available sensor
location, 128
when to clean, 124
labels did not print, 147
language
changing from unreadable language, 149
selection, 89
LCD messages
adjust LCD settings, 88
error messages, 139
language selection, 89
Setup mode, 63
liability, ii
list settings
all settings, 73
bar codes, 72
fonts, 72
formats, 73
images, 73
setup, 73
load factory defaults, 59
loading
ribbon, 41
long calibration, 48
lower media sensor adjustment, 52
M
mark LED setting, 87
Mark Med S. setting, 87
maximum label length setting, 68
media
continuous roll media, 27
fanfold, 27
loading, 34
media LED setting, 87
non-continuous roll media, 26
ordering, 3
setting media type, 66
specifications, 182
types of media, 26
media and ribbon sensor calibration procedure, 77
media compartment cleaning, 125
media door, 8
media liner removal, 120