Brady X-Plus II - Manual (Page 23)

13 Introduction
Control Panel
1/11/07 X-Plus II User Guide 14068L-001 Rev. A
Control Panel Indicator Lights
Table 2 describes lights on the control panel that indicate different printer conditions.
Note • If two operating conditions occur simultaneously (for example, one that causes a light
to be on constantly and one that causes the same light to flash), the indicator light flashes.
Table 2 • Control Panel Indicator Lights
Light Appearance Status Indication
POWER Off The printer is off or power is not applied.
On The printer is on.
TAKE
LABEL Off Normal operation.
Flashing (Peel mode only.) The label is available. Printing pauses
until the label is removed.
ERROR Off Normal operation—no printer errors.
Flashing A printer error exists. Check the LCD for more information.
CHECK
RIBBON Off Normal operation—ribbon (if used) is properly loaded.
On Printing is paused, the LCD displays a warning message,
and the PAUSE light is on.
• If the printer is in Direct Thermal Mode: ribbon is loaded.
• If the printer is in Thermal Transfer Mode: no ribbon is
loaded.
PAPER OUT Off Normal operation—media is properly loaded.
On No media is under the media sensor. Printing is paused, the
LCD shows an error message, and the PAUSE light is on.
PAUSE Off Normal operation.
On The printer stopped all printing operations. Causes include:
• PAUSE was pressed
• A label format included a pause command
• The online verifier detected an error
• A printer error was detected.
The LCD gives additional information.
DATA Off Normal operation. No data being received or processed.
On The printer is processing data or is printing. No data is being
received.
Flashing The printer is receiving data from or sending status
information to the host computer.