Brady X-Plus II - Manual (Page 75)

65 Configuration
Control Panel Parameters
1/11/07 X-Plus II User Guide 14068L-001 Rev. A
Adjust the Tear-Off Position
This parameter establishes the position of the media over the
tear-off/peel-off bar after printing.
See Figure 24 . Higher numbers move the media out (the tear line moves
closer to the leading edge of the next label), and lower numbers move the
media in (the tear line moves closer to the edge of the label just printed).
Figure 24 • Tear-Off Position Adjustment
Default: +0
Range: –120 to +120
To change the value shown:
1. Press the right oval to increase the value. Each press adjusts the tear-off
position by four dot rows.
2. Press the left oval to decrease the value. Each press adjusts the tear-off
position by four dot rows.
Select Print Mode
Print mode settings tell the printer the method of media delivery that you
wish to use. Make sure that your printer can support the selected option.
Default: TEAR-OFF
Selections: TEAR-OFF, PEEL-OFF, CUTTER, DELAYED CUT,
APPLICATOR, REWIND
To change the value shown:
1. Press the left or right oval to scroll through the options.
Table 9 • Printer Parameters (Sheet 2 of 26)
Parameter Action/Explanation
TEAR OFF +000
- +
1
Media direction
2
Factory-set tear line location at position 00
1
2
PRINT MODE
-TEAR-OFF +