Brady X-Plus II - Manual (Page 153)

143 Troubleshooting
Print Quality Problems
1/11/07 X-Plus II User Guide 14068L-001 Rev. A
Print Quality Problems
Table 12 identifies problems with print quality, the possible causes, and the recommended
solutions.
Table 12 • Print Quality Problems
Problem Possible Cause Recommended Solution
General print quality
issues The printer is set at the
incorrect print speed. For optimal print quality, set the print speed to
the lowest possible setting for your application
via control panel, the driver, or the software. See
Adjust Print Speed on page 64 . You may wish to
perform the FEED Self Test on page 154 .
You are using an incorrect
combination of labels and
ribbon for your application. 1. Switch to a different type of media or ribbon
to try to find a compatible combination.
2. If necessary, consult an authorized Brady
distributor for information and advice.
The printer is set at an incorrect
darkness level. For optimal print quality, set the darkness to the
lowest possible setting for your application via
the control panel, the driver, or the software. See
Adjust Print Darkness on page 64 . You may wish
to perform the FEED Self Test on page 154 to
determine the ideal darkness setting.
The printhead is dirty. Clean the printhead. See Clean the Printhead
and Platen Roller on page 125 .
Wrinkled ribbon Ribbon fed through the
machine incorrectly. See Load Ribbon on page 41 .
Incorrect burn temperature. Set the darkness to the lowest possible setting for
good print quality. See
Adjust Print Darkness
on page 64 .
Incorrect or uneven pressure. Set the pressure to the minimum needed for good
print quality. See
Adjust Printhead Pressure and
Toggle Position on page 53 .
Media not feeding properly;
“walking” from side to side. Make sure that media is snug by adjusting the
media guide, or call a service technician.
The strip plate needs adjusting. Call a service technician.
The printhead needs vertical
adjustment. Call a service technician.
The printhead and platen roller
need to be realigned. Call a service technician.
Long tracks of
missing print on
several labels Print element damaged. Call a service technician.
Wrinkled ribbon. See wrinkled ribbon causes and solutions in this
table.
Fine, angular gray
lines on blank labels Wrinkled ribbon. See wrinkled ribbon causes and solutions in this
table.