Rockwell Automation 193-DNCT DeviceNet Configuration Terminal User Manual - Manual (Page 76)

72 Rockwell Automation Publication 193-UM009B-EN-P - February 2013
Chapter 17 Terminal Setup Menu
Note : Once the primary password is set, it must be logged in to edit secondary
passwords.
Entering a Password
When the operator attempts to access a menu that is password protected the
following box will appear for password entry:
Resetting Forgotten Passwords
Using RsNetworks for DeviceNet™, find the DNCT on the network, and set
parameter 2 - Password Override to override. This will temporarily override the
password in the DNCT. The old password can then be viewed and changed from
the DNCT. The password is only overridden until the DNCT is powered down.
Auto Display The auto display feature allows the 193-DNCT to be setup so that on power up,
it will connect to one or more devices and display 1…4 values from 1…4 devices.
This allows the unit to automatically monitor device values without any
Bit Field
selected. Use
the Left/Right
arrow keys to
move the cursor
to the next bit.
This screen
shows bit 0
selected. Bit Field privileges:
Bit0 = Parameter Edit
Bit1 = CopyCat
Bit2 = Graph Setup
Bit3 = Node Commissioning
Bit4 = CIA Editor
Bit5 = DeviceLogix™
Bit6 = ZIP
Bit7 = Scanner Setup
Bit8 = UserKeys
Password
Value
Password
entry box