Rockwell Automation 193 193-5.0: Bulletin 913/592 SMP-3 Solid-State Overload Relay User Manual
Page 59
Chapter 4 – Functional Description
4-11
Communication Parameters. (cont.)
[Mask]
The mask parameter can be used to program or
identify the communication adapter devices that are
enabled and/or disabled. Refer to Chapter 8 for
Logic Mask Programming instructions
Parameter #
7
Parameter Type
Read/Write
Units
Byte
Factory Default
00000110
Settings
1 Permit Control (enabled)
0 Deny Control (disabled)
Bit
A apter
er
ett g
E p a at
7
6
5
4
3
2
1
0
Adapter Number
Setting
Explanation
X
Not Used
—
—
X
Adapter 1
1
0
Enabled (Unmasked)
Disabled (Masked)
X
Adapter 2
1
0
Enabled (Unmasked)
Disabled (Masked)
X
Not Used
—
—
X
Not Used
—
—
X
Not Used
—
—
X
Not Used
—
—
X
Not Used
—
—
[Status]
This parameter is a 16 bit common status message
interpreted by the HIM and transmitted by all serial
port master devices. The message status contents
for the SMP-3 overload relay are defined in Table
4.A.
Parameter #
8
Parameter Type
Read Only
Units