Rockwell Automation 193 193-5.0: Bulletin 913/592 SMP-3 Solid-State Overload Relay - Manual (Page 67)

Chapter 5 – Human Interface Module
5-5
Note: Earlier versions of the HIM may require the user to
press ESC (Escape key) to return to the fault default status
display.
Overload
F2
Trip/Test
F1
Phase Loss
F3
Ground Fault
F4
Jam/Stall
F5
Illegal FLC Set
F6
Non Vol Mem Fault
F7
Comm Fault
F8
HIM MODES
The SMP-3 HIM supports four modes: display, program,
search, and control status mode.
The menu structures are dictated by the master device. So a
drive HIM used with a SMP-3 overload relay will provide the
same menu scheme and modes as a SMP-3 HIM used with a
SMP-3 overload relay. (Assuming both have the same code
release).
Note: Earlier versions of HIMs may only support the display
and program modes.
Display Mode
When selected, the Display Mode allows you to view all eight
of the SMP-3 communication parameters. However, in Display
mode the SEL key is disabled to prevent the parameters from
being modified.
The SMP-3 parameters can be viewed by using the following
steps: