Rockwell Automation 193 193-5.0: Bulletin 913/592 SMP-3 Solid-State Overload Relay - Manual (Page 68)

Chapter 5 – Human Interface Module
5-6
ACTION DESCRIPTION HIM DISPLAY
or
ESC SEL
To Select Mode
1. Press any key to go from the Status Display to the Choose Mode
menu.
2. Press the up/down keys to toggle to “Display” in the display.
3. Press Enter to go to the Display menu. (If this is the first time that
the display mode is entered since the last power-up, the display will
start with parameter 1. Otherwise the display will start with the last
parameter displayed). The parameter number is located on the right
side of the value line.
4. Press Up for the next display parameter.
A=OXX B=OXX
X.X AMPS
Choose Mode
Display
Average Current
X.X AMPS
1
FLC Setting
X.X AMPS
2
Thermal Cap Used
X%TCU
3
Current Unbal
X%CU
4
(Firmware Rev?)
X.xx
5
DEVICE PORT#
00000XX0
6
MASK (0–DISABLE)
00000XX0
7
STATUS
XXXXXXX
XXXXXXX
8