Rockwell Automation 193 193-5.0: Bulletin 913/592 SMP-3 Solid-State Overload Relay - Manual (Page 82)

Chapter 6 – Serial Communication
6-12
The following section of code transfers commands from the local rack control switches to the SMP-3 overload relay. These
commands control OUT A and OUT B, reset faults, and establish the analog parameter that is to accompany the status word from
the SMP-3 overload relay.
Rung 2:16
Output Local Rack Control Switches (Rack 0,Word 1,Bit 0–4) to SMP (Rack 2,Word 0, Bit 0–4).
Bit 0 – Output A Off
Bit 1 – Output B Off
Bit 2 – Reset
Bit 3 – Output A ON
Bit 4 – Output B ON
| +BTD–––––––––––––––+ |
+–––––––––––––––––––––––––––––––––––––––––––––––––––––––––+BIT FIELD DISTRIB +–+
| |Source I:001| |
| | 24| |
| |Source bit 0| |
| |Destination O:020| |
| | 24| |
| |Destination bit 0| |
| |Length 5| |
| +––––––––––––––––––+ |