Rockwell Automation 193 193-5.0: Bulletin 913/592 SMP-3 Solid-State Overload Relay - Manual (Page 69)

Chapter 5 – Human Interface Module
5-7
Program Mode
When selected, the program mode is used to view the SMP-3
communication parameters or program the SMP-3 Logic Mask
parameter. The difference between Program and Display Mode
is that in Program Mode the first character of the text line
flashes to indicate that the parameter value can modified.
Refer to Chapter
8 for instructions on programming.
Search Mode
When selected, the search mode will indicate which
programmable parameters are not at default settings. Since
Logic Mask is the only programmable parameter, it is the only
parameter that is verified.
Control Status Mode
When selected, the Control Status mode allows you to quickly
mask out/disable the HIM.
When using this mode, the HIM will automatically program the
control bit of the Logic Mask which represents the HIM. Refer
to Chapter 8 for details about programming the Logic Mask in
Control Status Mode.
Note: Only the HIM can be masked out using the Control
Status Mode.
Note: The start/reset Disabled LED will be energized when the
SMP-3 is masked out regardless of the mode used to perform
the masking.