Rockwell Automation 193 193-5.0: Bulletin 913/592 SMP-3 Solid-State Overload Relay - Manual (Page 64)

ESC
SEL
RESET
Chapter 5 – Human Interface Module
5-2
DISPLAY PANEL DESCRIPTIONS
Note: The following display panel descriptions apply to both
the SMP-3 HIM and the Drives HIM.
Escape
Use this key to cause the programming system to go
back one level in the menu structure.
Select
Use this key to indicate which line of the display
should be active. The first character of the active line
will flash.
Up/Down Arrows
Use these keys to increment and decrement a value or
scroll through the parameter list.
Enter
Press this key to select a parameter or enter a
parameter value into memory. After you have entered
a parameter into memory, the top line of the display
will automatically become active, allowing you to
choose another parameter (or group).
CONTROL PANEL DESCRIPTION
SMP-3 HIM Control Panel Description
Note: The Reset, Out A ON, Out B ON keys of any HIM can
be masked out (See Chapter
8 ). The OFF keys, however can
not be masked out. All OFF keys are always functional.
Reset
Press this key to reset a SMP-3 overload relay fault if
it is clearable. This operation is edge-sensitive and
trip-free, that is, holding the key down will not
prevent the SMP-3 overload relay from
tripping/faulting. This functionality can be masked
out.
OUT A
Out A ON
Press this green key to energize output A (terminal
10). This functionality can be masked out.
Press this red key to de-energize output A (terminal
10).