Rockwell Automation 193 193-5.0: Bulletin 913/592 SMP-3 Solid-State Overload Relay - Manual (Page 66)

Chapter 5 – Human Interface Module
5-4
Drives HIM Control Panel Description
Press this green key to energize output A (terminal
10). This functionality can be masked out.
Press this red key to turn off both output A and B.
Pressing the same red key to reset the SMP-3
overload relay when a fault exists.
Note: OUT B can not be energized with a Drive HIM.
HIM STATUS DISPLAY
The HIM contains a 2-line, 16-position alpha-numeric display.
The top line is the text line while the bottom line is the value
line:
XXXXXXXXXXXXXXX
XXXXXXXXXXXXXXX
Text Line
Value Line
When a HIM is connected to a SMP-3 overload relay, the HIM
display will display a series of start-up screens (as indicated in
Chapter
7 ). Eventually, it will display a default status display.
There are two styles of status displays for the SMP-3 overload
relay: an OUT A/B status and a fault status display. If the
HIM is connected to an unfaulted SMP-3 overload relay that
display will indicate the status of outputs A and B and the
average current through the SMP-3 overload relay:
A=OFF B=ON
0.0 AMPS
A=OFF B=ON
0.0 AMPS
A=ON B=ON
0.0 AMPS
A=OFF B=OFF
0.0 AMPS
A user can always view the status display by pressing escape
until it is displayed.
If the SMP-3 overload relay faults while the HIM is connected
to it, the HIM display will automatically default to one of the
eight fault status displays. the fault status display will indicate
the fault cause and fault code. The fault code (i.e. F2)
corresponds to the number of flashes (i.e. “2”) on the SMP-3
Trip LED.