Rockwell Automation 1769-ADN Compact I/O 1769-ADN DeviceNet Adapter - Manual (Page 124)

Publication 1769-UM001B-EN-P - October 2002
6-12 Application Examples
Configuring the Logix5550 TM Controller System
Configure your Logix5550 system by selecting the 1756-DNB module
under I/O configuration in RSLogix 5000 programming software. For
more information on configuring your controller or writing the
controller program, refer to your ControlLogix documentation.
The following sections will guide you through configuring your
1756-DNB module to produce output data to the 1769-ADN and
consume input data from the 1769-ADN. You’ll see how the I/O data
is mapped into the Logix5550 controller, allowing you to then write
your control program.
Configuring the 1769-ADN DeviceNet Adapter
Start RSNetworx for DeviceNet. You’ll see this screen.
At this point, you could configure your network devices offline and
download these configuration files to the network devices. Instead,
we will go online to configure our network. Refer to chapter 3 for
information on configuring your DeviceNet system offline.
The advantage to configuring your system online is that the
RSNetworx software can upload the keys of the actual devices present
in the Compact I/O system - its I/O modules, power supplies,
inter-rack cable, and end cap - to use for adapter configuration.
All you’ll need to do is configure the individual I/O modules.