Rockwell Automation 1771-ASB/E Remote I/O Adapter User Manual - Manual (Page 26)

Y
N
N
Y
USING
POWER SUPPLY
MODULE IN
THIS CHASSIS?
I/O Chassis
Power Supply
Configuration
Plug
Y N
2–12 Installing Your Module
Publication 1771-UM001A-US-P - February 2000
You use the I/O chassis power-supply configuration plug (Figure
2.13) to identify the type of power supply you use with your remote
chassis. This configuration plug is located on the backplane of series
B I/O chassis.
Figure 2.13
Series B I/O Chassis Power Supply Configuration Plug
Settings
ForUse With: Set Chassis Configuration Plug to:
power supply module installed
in chassis
Y" position
external power supply in your
remote system
N" position
The field wiring arm provides connection points for:
•
I/O communication cables
•
a user-supplied I/O chassis restart pushbutton
The wiring arm pivots on the front of the chassis to connect with the
module’s printed circuit board, allowing you to remove the adapter
module without disconnecting the system wiring.
Connect input/output cables to the field wiring arm as shown in
Figure 2.14.
Setting the I/O Chassis
PowerSupply
Configuration Plug
Wiring the Field Wiring
Arm