Rockwell Automation 2755 Cordless Hand-Held Scanner - Manual (Page 22)

Chapter
2
Publication 2755-6.3
Installing Your Hardware
This chapter describes how to install your hardware. Included is the
following sequence on installing your scanner system hardware.
1. unpacking the equipment
2. setting the address of the base/charger unit
3. connecting the host cable to the base/charger unit
4. mounting the base/charger unit
5. mounting the power supply
6. connecting the power supply to the base/charger unit and power
receptacle
7. connecting the host cable to the host device
8. charging the battery
9. pairing the scanner to the base/charger unit