Rockwell Automation 2755 Cordless Hand-Held Scanner - Manual (Page 32)

Installing Your Hardware 2–11
Publication 2755-6.3
7. Connecting the Host Cable to the Host Device
The following sections describe how to connect the host cable to the
host device.
Connecting a RS-232C Cable to the Host Device
!
ATTENTION: Do not install the RS-232C cable
(Catalog Nos. 2755-HCC-BR1-06 or -BR2-06) or
disconnect/connect the host device with power applied
to the host device. Failure to follow this caution may
result in damage to the base/charger unit, RS-232C
cable, or host device.
To connect the RS-232C cable to the host device:
1. Disconnect power from your host device.
2. Plug the RS-232C cable into the host device.
To Host Device
RS-232C Cable
Base/Charger Unit
3. Reconnect power to your host device.