Rockwell Automation 2755 Cordless Hand-Held Scanner - Manual (Page 49)

3–12 Configuring Your Scanner
Publication 2755-6.3
Convert UPC-E to UPC-A
When enabled, this option converts UPC-E (zero suppressed)
decoded data to a UPC-A format before sending the data. After
conversion, output data will be affected by UPC-A programming
selections such as preamble and check digit settings.
EAN Zero Extend
When enabled, five leading zeros are added to decoded EAN 8
symbol data. The five zeros make the EAN 8 symbols compatible
with the EAN 13 format.
Transmit No Decode Message
When enabled, a NR is transmitted with each no-read. Prefixes and
suffixes appear with the output message.
UPC / EAN Supplemental
When enabled, supplemental digits are decoded. If the supplemental
digits are not enabled and a bar code having supplemental digits is
read, the supplemental digits are ignored. On the other hand, if
supplemental digits are enabled, only bar codes with supplemental
digits are decoded.
I 2 of 5 (14 digit) to EAN 13 Conversion
When enabled, 14 character Interleaved 2-of-5 data is converted and
transmitted to the host in an EAN 13 format. The I 2 of 5 code must
be enabled, have one length set to 14, have a leading zero, and have
a valid EAN-13 check digit.
Code 39 Check Digit
When enabled, the scanner verifies the Code 39 check digit
(modulo 43 check character).