Rockwell Automation 2755 Cordless Hand-Held Scanner - Manual (Page 28)

Installing Your Hardware 2–7
Publication 2755-6.3
4. Mounting the Base/Charger Unit
The base/charger unit can be mounted horizontally or vertically as
shown below.
!
ATTENTION: Do not mount the base/charger unit in
an enclosure. RF communication between the gun and
the base/charger unit will be affected by the enclosure.
Also make sure the location of the base/charger unit
will not interfere with data transmission between the
scanner gun and the base/charger unit. Material placed
near the base/charger unit may absorb the RF signal
intended for the base/charger unit.
Or
Host Cable
Host
Cable
To mount the base/charger unit:
1. Attach the rubber feet to the underside of the base/charger unit.
Rubber Feet