Rockwell Automation 2755 Cordless Hand-Held Scanner - Manual (Page 59)

3–22 Configuring Your Scanner
Publication 2755-6.3
Configuration Sequence
To configure the scanner:
1. Connect the base/charger unit to the host device. Refer to
Chapter 2 for more information.
2. Make sure the scanner gun has a fully charged battery. Refer to
Chapter 2 for more information.
3. Pair the scanner to the base/charger unit. Refer to Chapter 2 for
more information.
4. Decide if the default values meet your requirements. Refer to
page 3–3 for a listing of the default parameters. If the default
values meet your requirements, scan the Set Defaults bar code
located in the Hand-Held Cordless Bar Code Scanners
Programming Guide (Publication No. 2755-6.6). If the default
parameters do not meet your requirements, scan the appropriate
bar codes for the options you need found in the Hand-Held
Cordless Bar Code Scanners Programming Guide (Publication
No. 2755-6.6). It is recommended that you scan the Set Defaults
bar code before entering any additional bar codes. The scanner
parameters may be configured in any sequence.