Rockwell Automation 2755 Cordless Hand-Held Scanner - Manual (Page 23)

2–2 Installing Your Hardware
Publication 2755-6.3
Important Notes on Scanner Systems
The following illustrates the base/charger unit connected to the host
device and power supply.
Host
Power Supply
Base/Charger Unit
Be aware of the following when setting up your scanner system.
•
The gun operates up to 50 ft (15.24 m) from the host device
depending on the application environment.
•
The gun turns itself off after each successful data transmission to
conserve battery life.
•
Average life of a battery charge is 8 hours. Replace or recharge
the battery at the end of the work shift.
•
There is a 1-to-1 pairing of guns to bases. (You cannot have
multiple guns paired to one base or one gun paired to multiple
bases.)
•
You need to pair the scanner with the base/charger unit after
replacing the battery in the scanner gun. Refer to page 2–16 for
information regarding pairing the scanner to the base/charger
unit.
•
The base/charger unit cannot be placed in an enclosure. RF
communication between the gun and the base/charger unit will be
affected by the enclosure. However, you should protect the
base/charger unit from airborne contaminants.
1. Unpacking the Equipment
Remove the scanner, base/charger unit, power supply, and host
interface cable from their packing and inspect for physical damage.
If there is damage, contact Allen-Bradley Global Technical Services
(GTS) at (216) 646-6800.