Rockwell Automation 2755 Cordless Hand-Held Scanner - Manual (Page 29)

2–8 Installing Your Hardware
Publication 2755-6.3
2. Attach the cable bracket to the underside of the base/charger unit.
Make sure you have attached the host interface cable first. You
can remove the bracket by prying it off of the base/charger unit
with a screwdriver.
Cable Bracket
3. Remove the mounting template from the installation instruction
sheet. The following figure shows the dimensions of the
base/charger unit.
Mounting Holes
0.875 in.
(22.23 mm)
1.5 in.
(38.1 mm)
4.75 in.
(120.65 mm)
9 in.
(228.6 mm)
4 in.
(101.6 mm)
1.5 in.
(38.1 mm)
1.75 in.
(44.45 mm)
4. Secure the template to the mounting surface.
5. Drill holes through the holes marked on the mounting template.
6. Remove the mounting template from the mounting surface.
7. Attach #10 flat-head or pan-head screws to your mounting
surface.