Rockwell Automation 2755 Cordless Hand-Held Scanner - Manual (Page 57)

3–20 Configuring Your Scanner
Publication 2755-6.3
Intercharacter Delay
When enabled, the host system has time to service its receiver and
perform other tasks between characters. You can choose up to
99 msec delay between transmission of characters. The default
parameter is set to zero.
Transmit Code ID Characters
The code ID identifies a scanned bar code symbol’s code type. If
enabled, the code ID is sent after the prefix and before the bar code
data. The code ID codes are:
•
A = UPC-A, UPC-E, or EAN 13
•
B = Code 39
•
C = Codabar
•
D = Code 128
•
E = Code 93
•
F = Interleaved 2 of 5
•
G = Discrete 2 of 5
The default parameter is disabled.
Transmit AIM Code ID
When enabled, the AIM code identifier is sent after the prefix and
before the bar code data. The identifier is a three character prefix.
Refer to AIM’s Guidelines on Symbology Identifiers for a
description. The default parameter is disabled.
Ignore Unknown Characters
When enabled, all data is sent except for unknown characters and no
error beeps are sounded. Unknown characters are those characters
that the host device does not recognize. When disabled, all data
containing one or more unknown characters is discarded and error
beeps are sounded. The default parameter is enabled.