Rockwell Automation 8720MC 8720MC Regenerative Power Supply User Manual - Manual (Page 132)

Default Settings of All Parameters
User's Setting
Setting Date
Default Value
750 V
150%
150%
0
28 Amps
65 Amps
130 Amps
190 Amps
195 Amps
380 Amps
570 Amps
027.b: 28 Amps
065.b: 65 Amps
130.b: 130 Amps
190.b: 190 Amps
195.b: 195 Amps
380.b: 380 Amps
570.b: 570 Amps
1.00 times
64 rad/sec
5.00 times
128 rad/sec
800 V
400V
550 V
10 kHz: For Model
8720MC-RPS027 and
8720MC-RPS065
5 kHz: For Model
8720MC-RPS190
6.0 microseconds
0.50 seconds
See the previous
section.
3.0 seconds (3)
See the previous
section.
1.000
On
On
Setting Range
275 to 750 V
0 to 150%
0 to 150%
0 to 999
027.b
065.b
130.b
190.b
195.b
380.b
570.b
027.b: 10 to 35Amps
065.b: 10 to 70 Amps
130.b: 20 to 140 Amps
190.b: 30 to 210 Amps
195.b: 30 to 215 Amps
380.b: 60 to 430 Amps
570.b: 90 to 645 Amps
0.01 to 10.0 times
1 to 3,000 rad/sec
0.01 to 30.00 times
1 to 3,000 rad/sec
325 to 900 V
200 to 600 V
200 to 550 V
5, 10 and 15 kHz
1.5 to 15.0 microseconds
0.05 to 3.00 seconds
100 to 8,000 micro-henry
0.5 to 15.0 seconds
50 to 2,000 W
0.900 to 1.100
OFF, On
OFF, On
Parameter Name
DC Bus Voltage Reference
FWD Current Limit
REV Current Limit
Password
Unit Selection
Rated Current
Current Control Proportional Gain
Current Control Integral Gain
Voltage Control Proportional Gain
Voltage Control Integral Gain
Bus Overvoltage Detection Level
Bus Low Voltage Detection Level
AC Overvoltage Detection Level
Carrier Frequency
Deadtime
Allowable Time for Instantaneous
Power Loss
AC Reactor Capacity
Precharge/Discharge Time
Wattage of Precharge/Discharge
Resistor
DC Bus Voltage Offset (1)
Discharge Function Enable (1)
Version Information
Selecting of Wiring Error (LE)
Detecting Function
(2)
Parameter
Number
User
Parameters
Factory
Parameters
U.000
U.001
U.002
F.000
F.001
F.002
F.003
F.004
F.005
F.006
F.007
F.008
F.009
F.010
F.011
F.012
F.013
F.014
F.015
F.016
F.017
F.018
F.019
B-2 Default Parameter Settings
(1) These parameters are available from software version No. 2.00 or later only.
(2) This parameter is available from software version No. 3.00 or later only.
(3) This parameter must be set to 6.0 seconds for 8720MC-RPS190 unit.