Rockwell Automation 8720MC 8720MC Regenerative Power Supply User Manual - Manual (Page 93)

The parameters are used to define characteristics of the 8720MC-
RPS Regenerative Power Supply. To program the unit for a
specific application, you display the appropriate parameter and
adjust it as required. This chapter provides information on
parameter types as well as detailed descriptions of each parameter.
This chapter also describes how to access, display, and modify
parameters.
ATTENTION: Only qualified electrical personnel
familiar with the construction and operation of this
equipment and the hazards involved should adjust and
operate this equipment. Read and understand this
manual in its entirety before proceeding. Failure to
observe this precaution could result in destruction of
the equipment, severe bodily injury or loss of life.
There are two types of parameters:
1) User Parameters
These parameters can be adjusted or modified at any time.
2) Factory Parameters
These parameters are initially set before shipping out from the
factory. Usually, these parameters are not required to be
adjusted or modified.
The Factory parameters are protected by password, and the
adequate password must be set to access these parameters.
Note, however, that some of these parameters cannot be
modified during operation even though the password has been
set.
Each parameter is described in detail in this chapter. The following
information is provided for each parameter.
• Parameter Number
A unique number is assigned to each parameter. The number is
preceded by either U or F to identify it as a User or Factory
parameter, respectively. The parameter number is shown on the
display of the operation panel.
• Parameter Name
A name is assigned to a parameter. The parameter name is not
displayed when programming the 8720MC-RPS Regenerative
Power Supply using the operation panel.
Chapter
7
Parameter Types
Parameters
!