Rockwell Automation 8720MC 8720MC Regenerative Power Supply User Manual - Manual (Page 89)

Program Mode
Program mode allows you to display and modify parameter values,
and to display the error log. The following can be displayed in
program mode:
• Types of parameters
• Parameter numbers
• Parameter values
• Selection of error log
• Error log number
• Error codes.
In program mode, the "PROGRAM" status LED is ON, indicating
that the operation panel is in program mode.
The figure below shows an example of display in program mode.
The following figure shows an example of display in monitor mode.
6-3 Operation Panel
Display
RST PRG ENT
READY READY
FAULT FAULT
PROGRAM PROGRAM kW kW
V
A
The "PROGRAM"
status LED will
not turn ON.
A status LED ( "A",
"V" or "KW") will turn
ON, corresponding
to the selected
monitor display.
The display portion of the operation panel is a four-character,
seven-segment LED. When the unit is powered up, SELF is
displayed as the 8720MC-RPS Regenerative Power Supply
performs the power-up self-diagnostics. When the diagnostics are
completed, the display indicates various monitor values, parameter
numbers, parameter values and error codes.
RST PRG ENT
READY
FAULT
PROGRAM kW
V
A
The "PROGRAM"
status LED will
turn ON.