Rockwell Automation 8720MC 8720MC Regenerative Power Supply User Manual - Manual (Page 31)

Chapter
3
Installation Site
Installation
!
!
This chapter shows how to mount the 8720MC-RPS Regenerative
Power Supply properly, and provides information on the items to be
checked.
ATTENTION: Only qualified electrical personnel
familiar with the construction and operation of this
equipment and the hazards involved should install,
adjust, operate, or service this equipment. Read and
understand this manual in its entirety before
proceeding. Failure to observe this precaution could
result in destruction of the equipment, severe bodily
injury, or loss of life.
ATTENTION: The user is responsible for conforming
with all applicable local, national and international
codes. Failure to observe this precaution could result
in damage to, or destruction of, the equipment.
It is important to properly plan before installing the 8720MC-RPS
Regenerative Power Supply to ensure that the environment and
operating conditions of the units are satisfactory. Read this section
before continuing with the unit installation.
Environmental Conditions to be Met
The Declaration of Conformity with the requirements for CE Mark
was issued for the following units, and these units must be used in
cabinet.
8720MC-RPS027BM,
8720MC-RPS065BM, 8720MC-RPS065BS,
8720MC-RPS190BM and 8720MC-RPS190BS
Also, before deciding on an installation site, consider the following
guidelines:
• Verify that the units can be kept clean, cool and dry.
• Be sure that the units are always away from oil, metal powder,
other airborne contaminants, and direct sunlight.
• Check that the units will not be exposed to excessive vibration
and noise, and that they will not be close to instruments
sensitive to electrical noise.
• The area chosen should allow the space required for proper air
flow as defined in the following.