Rockwell Automation 8720MC 8720MC Regenerative Power Supply User Manual - Manual (Page 87)

This chapter describes the configuration of operation panel and the
operation modes.
The operation panel is used for setting parameters, monitoring
operating conditions and resetting faults. The figure below shows
the configuration of the operation panel and the names of the
components.
On the keypad of the operation panel, there are five push-button
switches, to be used for selecting monitoring information, setting
parameters and resetting faults.
The display on the operation panel consists of four seven-segment
LEDs that display monitored values, parameter numbers, parameter
values and error codes.
Six status LEDs on the operation panel are used to display the
operation status and the units of the monitored values.
The operation panel operates in the two modes:
1) Monitor mode
2) Program mode
In monitor mode, you can monitor various operating conditions
including input current of the 8720MC-RPS Regenerative Power
Supply, DC bus voltage, etc.
In program mode, you can view and change parameter values, and
examine the error log.
Chapter
6
Configuration of the Operation
Panel
Operation Modes
Operation Panel
RST PRG ENT
READY READY
FAULT FAULT
PROGRAM PROGRAM kW
V
A
Status LED Display
Keypad