Rockwell Automation 8720MC 8720MC Regenerative Power Supply User Manual - Manual (Page 15)

About 8720MC-RPS Regenerative Power Supply 2-3
RST PRG ENT
POWER
READY READY
FAULT FAULT
PROGRAM PROGRAM kW kW
V
A
Main Power Terminal Block (TB1)
Regulator Board (only for Master Unit)
Sequence Signal Terminal Block (TB3)
Unit After Removing Front Cover
POWER
Control Power Terminal Block (TB2)
Unit After Removing Regulator Board
When the front cover is removed from the 8720MC-RPS027 and
8720MC-RPS065 , the main power terminal block (TB1) and the
Regulator Board (only for master unit) will appear as shown in the
following figure. To remove the front cover, first remove the screw
at the upper left corner of the unit, and then lift up the cover. Note,
however, that Model 8720MC-RPS027 has the cover fixing screw
at the upper right corner instead of the upper left corner. Do not
drop the screw from the cover.
The control power terminal block (TB2) for Model 8720MC-
RPS027 and 8720MC-RPS065 will be disclosed as shown in the
figure below, when the Regulator Board is opened to the left hand
side by removing the two fixing screws on the right hand side of the
bracket supporting the Regulator Board.