Rockwell Automation GV3000/SE AC Drive Ver. 6.06 Hdwe Ref., Installation, and Troubleshooting Manual - Manual (Page 55)

Mounting the Drive, Grounding, and Finding Wire Routing Locations 4-9
Figure 4.7 – Wire Routing Locations for 200-400 HP Drives
ALLOW 6 INCH RADIUS SERVICE LOOP
WITH INTERCONNECTION WIRING FROM
CONTROL BOARD WIRING TRAY TO
J1 CONNECTOR ON REGULATOR BOARD.
SIGNALS (VIA WIRING TRAY)
GROUND, A-C INPUT AND A-C OUTPUT TERMINALS
DANGER
OR LESS PRIOR TO SERVICING.
SLOTS SHOWN ABOVE. VOLTAGE MUST BE 50 VOLTS
VOLTAGE WITH A VOLTMETER THROUGH THE ACCESS CAPACITORS TO DISCHARGE AND THEN CHECK THE
WAIT FIVE (5) MINUTES FOR THE D-C BUS
AFTER INPUT POWER HAS BEEN DISCONNECTED.
D-C BUS CAPACITORS RETAIN HAZARDOUS VOLTAGES
VOLTMETER TEST POINTS +DC -DC
!
BM
1FU
2FU
OR EQUIV.
2A
LITTLEFUSE
CLASS CC
TYPE MR S
S
FU E U F
E
E S FU
UF E
E
S F UE
S U F S
V/T2
(with Cover Removed)
DC-
807300-
142A
GND DC+ U/T1 W/T3 R/L1 T/L3 S/L2 WIRING HARNESS 807300-138R
SIGNALS (VIA WIRING TRAY)
CONNECT USING 350MCM TWO HOLE TERMINAL LUGS
PULL SHIELD TABS IN AND ROTATE SHIELD OUT
GND
DANGER
TORQUE TO 325IN-LBS
DC+ DC- U V W R
POWER CONNECTIONS
W
IRI
NG
T
R
AY
S T
VIEW FROM TOP