Rockwell Automation GV3000/SE AC Drive Ver. 6.06 Hdwe Ref., Installation, and Troubleshooting Manual - Manual (Page 75)

Wiring the Regulator Board Terminal Strip 7-11
Table 7.8 - Wiring Signal and Control I/O to the Terminal Strip (Continued)
Terminal
Number Description Parameters/Wiring Connections
Wiring Analog Speed Reference Inputs
12
13
14
15
Isolated Reference
Voltage (+10VDC)
Analog Speed/Torque
Reference Input Voltage
(+/- 10VDC)
Analog Speed/Torque
Reference Input Current
(0-20mA)
Isolated Speed/Torque
Reference Common
(Voltage/Current)
Related parameters:
• P.000: Control Source
• P.009: Terminal Strip Analog Input Offset
• P.010: Terminal Strip Analog Input Gain
• P.011: Terminal Strip Analog Input Configure
Refer to the GV3000/SE Software Start-Up and Reference
manual for additional parameter information.
Jumper J4 must also be set. See figure 2.12.
Refer to Appendix G in the GV3000/SE Software Start-Up
and Reference manual (D2-3359) for more information about
the analog input.