Rockwell Automation GV3000/SE AC Drive Ver. 6.06 Hdwe Ref., Installation, and Troubleshooting Manual - Manual (Page 67)

Wiring the Regulator Board Terminal Strip 7-3
Table 7.6 – Snubber Resistor Braking Connections (Terminals 26 and 27)
Terminal # Signal
26 Snubber Resistor Braking Signal (1-10 HP Drives only)
27 +24 VDC Common
Notes: These terminals are used with older Snubber Resistor Braking kits that require
a gate turn-on signal from the drive (for example, the M/N 2DB4010 series).
Table 7.7 – Status Relay Connections (Terminals 28-31)
Terminal # Signal
28 N.C Relay Contact
29 N.C. Relay Common
30 N.O. Relay Contact
31 N.O. Relay Common
Notes: Relay contact closure is programmable through parameter P.013. Refer to the
GV3000/SE Software Start-Up and Reference manual for more information.