Rockwell Automation AADvance Controller Solutions Handbook - Manual (Page 50)

 

1-38 Document: 553631
(ICSTT-RM447J_EN_P) Issue: 09:
Solutions Handbook (AADvance Controller)
Field Wiring Connections
Field connections are made using industry-standard screw terminal blocks. Terminals
are readily accessible for future wiring modifications without needing to dismantle any
assemblies. This illustration shows field wiring to four simplex termination assemblies:
Corrective Maintenance and Module Replacement
Corrective maintenance is by module replacement. In dual and triple modular
redundant configurations, you can remove a module and install a new one without
interrupting the system opetration. In simplex configurations removing a module will
interupt the system operation.
Field connection wiring is attached at the connectors on the termination assemblies.
Ethernet and Serial data connections are made at the T9100 Processor Base Unit.
There are no physical links needed to be set up on any modules or base units.
Standard modules are used for all the different configurations.
The guidelines for replacing modules are given in the AADvance Safety Manual (Doc
no 553630).
Note: Processor modules must be replaced with a module containing the same
firmware revision, you cannot use processor modules with different firmware
revisions.