Rockwell Automation FactoryTalk Historian SE 3.0 H2H Interface User Guide - Manual (Page 103)

FactoryTalk Historian To Historian Interface User Guide 97
Chapter 10.
Interface node Clock
Make sure that the time and time zone settings on the computer are correct. To confirm, run
the Date/Time applet located in the Windows Control Panel. If the locale where the interface
node resides observes Daylight Saving Time, check the Automatically adjust clock for
daylight saving changes box. For example,
In addition, make sure that the TZ environment variable is not defined. All of the currently
defined environment variables can be viewed by opening a Command Prompt window and
typing
set . That is,
C:> set
Confirm that TZ is not in the resulting list. If it is, run the System applet of the Control
Panel, click the Environment Variables button under the Advanced tab, and remove TZ from
the list of environment variables.