Opt cont tab, Source host reconnection delay, Receiving host reconnection delay – Rockwell Automation FactoryTalk Historian SE 3.0 H2H Interface User Guide User Manual
Page 68
Startup Command File
62
Opt Cont Tab
Source Host reconnection delay.
This parameter sets the time delay for attempting to reconnect to source Historian Server after
a disruption. The number is entered in seconds and converted to milliseconds before being
saved in the batch file. This number must be between 1 second and 8 hours. (
/DELAYS=x,
default: 0 seconds
)
Receiving Host reconnection delay.
This parameter set the time delay for attempting to reconnect to receiving Historian Server
after a disruption. The number is entered in seconds and converted to milliseconds before
being saved in the batch file. This number must be between 1 second and 8 hours.
(
/DELAYR= x, default: 0 seconds
)
Suppress writing I/O Timeout to tags upon reestablishment of a lost
connection to the source Historian Server
When setting
Location3
to write “I/O Timeout” for any tags, use this parameter to suppress
the I/O Timeout state written to these tags upon reestablishment of a lost connection to the
source Historian Server. If this parameter is not set, the state written at reconnection will
prevent history from being recovered for the period of the disconnection. (
/TS
)