Rockwell Automation FactoryTalk Historian SE 3.0 H2H Interface User Guide - Manual (Page 74)

Startup Command File
68
.BAT .INI Description
/ist=tagname
Optional
-- Name of interface status tag.
/ist=<tagname>
where < tagname > is a digital tag on the
receiving Historian Server.
/ln=username
Optional
SourceLogin Login name of PI user on Historian 2 node.
This is used when source server is Historian
2.
/oc=#
Optional
Default:
/oc=30
-- Number of seconds between calculating time
offset between the interface and Historian
Server nodes.
/ps=x
Required
--
The /ps parameter specifies the point
source for the interface. X is not case
sensitive and can be any single or multiple
character string. For example,
/ps=P and
/ps=p are equivalent.
The point source that is assigned with the
/ps parameter corresponds to the
PointSource attribute of individual Historian
Points. The interface will attempt to load only
those Historian Points with the appropriate
point source.
/pw=password
Optional
SourcePassword Login password of PI user on Historian 2
node. This is used when source server is
Historian 2.
/sf=filename
Required for Historian
2 source
SecurityFile Used for locating the security file on a PI2
source server.
This switch specifies the <name> part of the
file name. Note that the complete file name
must have this format:
PItoPI<name>.SEC
where <name> is the portion specified by
/sf
/src_host=name:
port
Required
SourceHost Name or IP address of source Historian
Server.
/src_host=node_name:tcpip_port
The port number is 545 (Historian 2) or 5450
(Historian 3).