Rockwell Automation FactoryTalk Historian SE 3.0 H2H Interface User Guide - Manual (Page 107)

FactoryTalk Historian To Historian Interface User Guide 101
Source System Manager
1. The file PISysDat:PIServer.dat will be used to provide overall security for the
FactoryTalk Historian database. In this file, the receiving node must be given at least
read-login access.
2. Create and maintain a security file for each FactoryTalk Historian to Historian
interface that will read data from the source system. This file is
PISYSDAT:PITOPITEST.SEC, where
TEST is the file name specified on the
receiving node PIToPI command line.
3. A PI username and password must be provided which the interface will use as its
Historian login.
Note: Revisions to the security file are checked every 30 minutes.
Sample Security Files
Sample 1
I! Mode is set to include.
T! Specification type set to tag masks.
! Default to including all points in system.*
X! Reset mode to exclude.
T!
! All tags ending in „.al‟ are excluded.
*.al
unit?flow.*
S! Point source specifications.
? ! All fractal tags are excluded.
E!
Sample 2
X! Mode is set to exclude.
T! Tag specifications.
! Default to excluding all tags not explicitly matched.*
I!
T!
! Some tag masks with wildcards.
! multiple wildcards may be used.
cd*
*unit1*
! Match two of any characters.
reactor1.??
! Some tag names.
Sinusoid
le420
S! Point source specifications.
! All PE tags included.
C
! Only point source „P‟ with Location1 = 2 included.
P2