Location tab, Override location 1, Override location 2 – Rockwell Automation FactoryTalk Historian SE 3.0 H2H Interface User Guide User Manual
Page 65: Override location 3, Override location 4, Override location 5
FactoryTalk Historian To Historian Interface User Guide
59
Location Tab
Use the Override Tag Location Code Settings check boxes to configure the interface to ignore
individual tag location codes and to apply specific settings for each of the location codes.
Override Location 1
Ignore
Location1
for each tag and load all tags configured for the specified point source
regardless of
Location1
and interface ID values. (
/C1
)
Override Location 2
Ignore
Location2
for each tag and set
Location2
value to be this number for all interface
tags. (
/C2=x
)
Override Location 3
Ignore
Location3
for each tag and set
Location3
value to be this number for all interface
tags. (
/C3=x
)
Override Location 4
Ignore
Location4
for each tag. The value used here should be 1, to have all points for the
interface sign up for exceptions, or 2, to have all points retrieve history only. (
/C4=x
)
Override Location 5
Ignore
Location5
for each tag and set all points for the interface to the same value of this
parameter (i.e., 0, 1, 2, or 3). (
/C5=x
)