Metrohm Vision Manual User Manual
Page 163
▪▪▪▪▪▪▪
161
project.
Once a calibration equation is connected to a library in the Operations Method, you will not be able
to change the library specified for this method.
1.
Click on Quant Setup to attach calibration equations to library or project database products.
The Operations Method Product Selection window appears.
2.
From the Product drop-down list select a product from the selected library or the active
project
3.
Expand the tree with projects below and double-click on the equation you want to link to the
product.
4.
Click on the letter designating the empty column to highlight the whole column and then
double-click on the new equation in the project tree, if you want to add more equations.
5.
To enter the tolerance limits and control chart parameters, click on the proper cell of the
spreadsheet and typing in the numbers.
6.
To replace the existing equation, click on the constituent name to highlight the whole column
and then double-click on the new equation in the project tree. Select the Inset Mode from the
field below the tree. If you are in the Change Constituent mode, the whole equation is
replaced. If you are in the Change Equation Only mode, the constituent name is not replaced.
7.
To delete an equation from a product, click on the constituent name to highlight the whole
column and then click on Delete.
8.
Click on Save to complete the links and on “Done” to close the window.