Metrohm Vision Manual - Manual (Page 190)

188 ▪▪▪▪▪▪▪
the timer window select Timed Acquisition and Prompt for Sample/Product Information. Make
sure that No Delay Between option is selected. Choose the reference frequency and click on
OK.
Now you can start Routine Analysis. After the reference is taken, the Sample Information
window is displayed. Vision attempts to analyze as Unknown when Identify is selected in
Operations Method, and as a product when only Qualify is checked. If you change to a
different product, it will become a default analyzed product.
Scanning a bar code (with the reader properly programmed) will enter the code into the
Sample ID field, and close the Sample Information window. Pulling the Smart Probe trigger
will start spectral acquisition.
As soon as the acquisition is complete and results calculated, the new Sample Information
window is displayed waiting for the new bar code.
Bar code reader feature is intended to be used with Smart Probe, but can be used with other
sampling modules as well. In this case it is recommended to select Keyboard Sample Ready Driver.
When Continuous Sample Ready driver is selected, Vision will start data acquisition immediately after
the bar code is scanned.