Metrohm Vision Manual - Manual (Page 187)

▪▪▪▪▪▪▪ 185
6.7 Setting up the Routine Analysis (RA) Operator
The RA Operator can perform only limited set of functions:
• Run Routine Analysis with pre-configured Operations Method
• Change own password
• Exit Vision
• Archive output project
The Operations Method for RA Operator has to be configured by the System Manager. To setup the
RA Operator follows these steps:
• Make sure you are logged into Vision as a System Manager
• Create and configure Operations Method so it is ready to use.
• Create and configure the RA Operator user.
Give the user ID and password to the Routine Analysis Operator.
Give the RA Operator user access to the project with Operations Method. Make sure the
proper project is opened. Click on File/Project/Edit Users from Data Acquisition menu. The
following window opens: