Metrohm Vision Manual - Manual (Page 61)

▪▪▪▪▪▪▪ 59
• To delete multiple Sample ID names, highlight those fields, and use the “Delete” key on the
PC keyboard. Vision will ask for confirmation, as shown.
Order of Sampling
• There are multiple ways to set the order of vial sampling. As a rule, it is faster to sample in the
sequence of the “Order” column, since this involves less movement of the Tablet sampling
mechanism. This saves positioning time. If the Sample ID for each sample is entered in order,
as below, this is automatic.
• At the bottom of the Vial Dialog screen is a checkbox marked Use Order. If this box is
checked, the MultiVial analyzer will start with the sample marked “1” in the “Order” column,
and proceed numerically upward through the order designated in the “Order” column.
• If this box is left unchecked, the MultiVial analyzer will proceed from vial position 1, to 2, to 3,
in numerical order of the physical vial position in the tray. Vision will ignore the “Order”
column.
• If the user plans to enable “Use Order” it is important to set the order correctly. To change
the order, follow these steps:
• Click on each vial position to be changed.
• Re-click and that vial’s “order” will be sent to the end of the sequence.
• Because this may be difficult to achieve by setting one vial at a time, click on all vial positions,
to turn them white. Then click on each one, in the order desired. This will set the “Order”
column to the proper sequence.
• Click on “Use Order” to have Vision follow the designated order.