Metrohm Vision Manual - Manual (Page 28)

26 ▪▪▪▪▪▪▪
In the Sample Frequency field:
• Enter the sample acquisition interval in seconds
• Enter the delay time for start of the timer
• In the reference frequency field select the reference acquisition interval.
• Enter the proper setting in the Timer Mode field:
• Timed Acquisition setting activates both sample and reference timer
• When sample and reference scans are coincident, Vision will scan reference first,
unless the check box is marked.
• Click on “OK” when done.
• Configure the Autosave function as described above.
• Vision will start timed data acquisition according to the timer settings.
• In order to stop the data acquisition timer click again on Acquire/Timer.