7 changing the ip address, Changing the ip address – Metrohm Vision Manual User Manual
Page 94
92
▪▪▪▪▪▪▪
•
Network cards: Metrohm does not recommend the use of two network cards. If multiple
communication channels are required, use a hub.
3.16.7
Changing the IP Address
Changing the IP Address of the computer
•
Use the IPConfig Utility in Windows
Changing the IP Address of the XDS instrument:
•
Go to Windows/Accessories/Notepad
•
Enter the following exactly as shown:
•
[Set IP]
•
Do Update=1
•
IP=XXX.XXX.XXX.XXX
•
Subnet=XXX.XXX.XXX.XXX
•
Optionally add the line
•
Gateway=63.121.141.1
•
This is usually done by IT people who know if this line is required.
•
Fill in IP address you need to replace XXX. The same for Subnet mask.
•
Save the file as “xds_set_ip.ini” in the Vision directory.
•
Open Vision and go to Status on the tool bar.
•
When the Status dialogue is displayed, click on Update. A message “The IP address has been
changed successfully” will be displayed
•
Close Vision, recycle power to the instrument and re-open Vision. You are ready to go!