Great Plains NTA2007HD Predelivery Manual - Manual (Page 53)

Great Plains Manufacturing, Inc. Contents Index Implement Assembly 49
02/09/2011 Contents Index 166-283Q
Install Transfer Valve
Refer to Figure 81
(which depicts this area at a later stage of assembly)
191. Remove port cap (if any) at base end port of right
weight transfer cylinder. Install the solenoid valve
assembly
at the base port, using the MORB
port of the tee. Orient the assembly so that the
MJIC elbow near the coil points at the rod end of the
cylinder.
Null4:
Install Fittings and Trees
Install Transfer Fittings
Refer to Figure 82
(which depicts this area with hoses added later)
192. Select one each:
811-470C TE 9/16MJIC 3/4MORB 9/16MJIC
If the fitting is pre-assembled on the valve, skip to
step 193. Otherwise, install the elbow
on the
rod end of the right weight transfer valve. Point the
MJIC end at the base end of the cylinder.
193. Select one each:
811-249C TE 9/16MJIC 3/4MORB 9/16MJIC
811-169C EL 9/16MJIC 9/16FJIC
Install the MORB end of the tee at the base end
of the left transfer cylinder. Install the FJIC end of
the elbow
on the left end port (not the mid port)
of the tee. Point both unconnected MJIC ports
toward the rod end of the cylinder.
194. Select one each:
841-204C AD 9/16FJIC 3/4MORB
811-581C CR 9/16MJIC
811-169C EL 9/16MJIC 9/16FJIC
Connect the MJIC adaptor to any port of the
cross .
Add the elbow to the opposite port of the cross.
Install the MORB end of the adaptor at the rod
end port of the left weight transfer cylinder.
Null4:
Null4:
Figure 81
Install Transfer Valve
Q0056
258
270 292
264
258
Null4:
Figure 82
Transfer Cylinder Fittings
31273
U
D
F
B
L
R
273
266
270
292
266
272
272
272
270
266
270
266
292
273
266
292
273
266
292