Great Plains NTA2007HD Predelivery Manual - Manual (Page 68)

64 Great Plains Manufacturing, Inc. Contents Index NTA607HD
166-283Q Contents Index 02/09/2011
Install POM and Harness
Refer to Figure 114
262. Select one:
160-762D WSMB MODULE MOUNT PLATE
and two sets:
802-705C HHCS 5/16-18X5/8
804-009C WASHER LOCK SPRING 5/16 PLT
Position the plate in front of the threaded
mount on the center fold cylinder lug. Secure with
bolts and lock washers at the lower holes
of the plate.
263. Select one:
467982000S1 PLNTR CNTRL OUTPUT MODULE(POM)
and two sets:
802-224C HHCS 1/4-20X1 1/4 GR5
804-006C WASHER LOCK SPRING 1/4 PLT
803-006C NUT HEX 1/4-20 PLT
With the receptacles facing down and the mounting
ears forward, mount the POM
on the upper rear
face of plate . Secure with bolts , lock
washers and nuts .
Note: The middle holes, and front face, of the plate
are reserved for an option (marker sequence valve;
see manual 113-850M).
264. Select one:
467983502 DJ 2SOL YP24LIFT/HITCH FCM HRN
Connect this harness assembly to the monitor
extension installed at step 261.
Refer to Figure 115
265. Plug the 12-pin connectors of this cable
assem-
bly into the POM .
266. Select one:
467980485 TWO SOLENOID Y HARNESS
Plug the common connector of this Y-harness
into POM cable assembly
.
Connect one side of the Y to the lead at the right
wing fold solenoid valve
.
Refer to Figure 110 on page 62
267. Route the other side of the Y through the bottom
right clip of right hitch portal clamp (shared with
the lift switch cable).
Connect this side of the Y to the lead at the right
cart transfer solenoid valve
(not visible in
Figure 115)
Null4:
Null4:
Figure 114
Install Solenoid POM
Q0076
126
5
U
D
F
B
L
R
199
221
203
220
194
169
126
199
221
126
5
199 221
169
194
220
203
169
126 194
220 203
126
170
170
153
Null4:
Figure 115
POM Connections
Q0077
169
170
166
258
258
170
169
166
166
170
258
C03
258