ADS Environmental Services ADS TRITON+ QR 775027 A3 - Manual (Page 138)

Communication 4-7
 Commercial asphalt cold patch compound (approximately 1
cup)
 Scotch-kote electrical sealing compound (ADS p/n 505171)
 Scotch 130C rubber stretch tape (ADS p/n 145-0001)
Installing the Wireless Antenna
Install one of the following antennas for connection to the
TRITON+ monitor:
 Wireless, slim, quad-band antenna (ADS p/n 3800-0162)
 Wireless, mini-wing, quad-band antenna (ADS p/n 3800-0163)
Slim (left) and mini-wing (right) antennas
Install a wireless slim or mini-wing antenna in the road, in the dirt,
or under other paving materials in the following way:
Note: While this section describes the process for
installing these antennas, all wireless antennas provided
through ADS also include detailed installation instructions.
1. Determine the appropriate location in the road near the
manhole to install the antenna:
 Locate the antenna in the road between 18 and 30 inches
(457 and 762 mm) from the manhole in which the monitor
is installed. Position the antenna as far as possible from
the massive iron frame and buried flange to prevent
shunting of the RF signal.