ADS Environmental Services ADS TRITON+ QR 775027 A3 - Manual (Page 300)

8-14 ADS TRITON+ Manual
 Run the wires up through the left cable gland on the XIO
into the enclosure. ADS recommends using 18-gauge
wiring. You may need to loosen the plastic nut on the
cable gland on the outside of the XIO to feed the wires
through.
XIO MODULE
CABLE GLAND
2 WIRES
Feeding wires up through left cable gland in XIO
 Insert one of the stripped ends of one of the wires into the
hole corresponding to terminal 9 (or 11) on the I/O
terminal block in the XIO.
 Insert one of the stripped ends of the other wire into the
hole corresponding to terminal 10 (or 12) on the I/O
terminal block in the XIO.