ADS Environmental Services ADS TRITON+ QR 775027 A3 - Manual (Page 269)

6-82 ADS TRITON+ Manual
Collecting Data from the Monitor
Note: TRITON+ monitors using SIMs with dynamic IP
addresses are capable of direct-serial or one-way, wireless
communication. Enable data collects for these monitors by
configuring and using the FTP Operations device. For
more information see Editing the FTP Operations Device,
page 6-61.
Collect data from a monitor in the following way:
1. Select the monitor from which you want to collect data from
the Location Name drop-down list in the Monitor section on
the ADS Qstart dialog.
2. Click on the Collect button in the Functions section.
The Collect Span dialog displays for designating the date/time
range for which you want to collect the data.
3. Designate the date and time from which you want to begin
collecting data from the monitor in the Start field. Qstart
defaults to a start date and time of one second past the last data
point stored in the local directory or network for the current
location. To edit a particular value in the Start date or time
field, select the value and enter a new value or use the up/down
arrows to advance through the numbers until you reach the
desired value.
4. Designate the date and time up to which you want to collect
data from the monitor in the End field. The end date and time
in Qstart default to the date and time on the local computer.
To edit a particular value in the corresponding date or time,
select the value and enter a new value or use the up/down
arrows to advance through the numbers until you reach the
desired value.
5. Click on the OK button.