Connecting the antenna to the monitor – ADS Environmental Services ADS TRITON+ QR 775027 A3 User Manual

Page 145

Advertising
background image

4-14

ADS TRITON+ Manual

SIM card released from secure position in holder

6. Replace the cap onto the SIM card enclosure, and snap the

locks in place to secure the cap.

7. Replace and reconnect the plastic tie between the locks holding

the cap on the SIM card enclosure.

Connecting the Antenna to the Monitor

Note: ADS recommends installing the antenna prior to
connecting the antenna to the monitor.

Connect the antenna to the monitor in the following way:

1. Place the monitor upright on the ground surface beside the

manhole in which the antenna cable is temporarily coiled.

2. Attach the antenna cable connector to the ANTENNA port on

the monitor top (first removing the electrical tape from the
cable end, when applicable).

3. Wrap rubber stretch tape around the entire cable connection,

extending onto the cable approximately 2 inches (50 mm)
beyond the connection with the antenna cable.

Advertising